I simply bent over the part that was soldered into the board, and then connected it to the positive terminal with a generous amount of solder. Once it's desoldered, you will need to connect it to the positive terminal. I used a pair of pliers to hold the terminal. Apply a generous amount of solder to your iron, and place it on the terminal right where it's soldered to the board, give it a good 10 seconds or so, and it should lift out with bit of a tug.īe careful not to burn yourself as the terminal will get extremely hot during this process. This is where it helps greatly to have a large "knife" tip on your soldering iron as you will need to transfer a vigorous amount of heat to the terminal to get the solder to melt. Now you will need to desolder the negative battery terminal from the circuit board. ![]() ![]() ![]() You won't need to remove the circuit board. Go ahead remove the back from the Game Boy Advance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |